What are the differences between “Super PH” and “Super Aid”?

Both are dehydrators, levelers and adherents. We have 2 different formulations. Depends on the client which product is better for her. Both are good.

The differences are: “Super PH” makes an inhibition layer and “Super Aid” is dry. If you have clients with difficult PH, use both of them and you will be able to ensure the applications of gel, Arquitek or Wonder.

 

What are the differences between rubber base and other bases?

Rubber base is a special one, is for clients who has thinner nails, therefore is ideal on applications of natural nail. It is more viscous and that is why it has more adherence. Before applying the color, you can apply 2 layers of rubber to strengthen the nails. It is also the ideal base for gel Arquitek and wonder applications.

 

Steps to follow to remove Arquitek and Wonder:

You need to use your bit of “banda verde” to remove Arquitek or Wonder. You have to reduce the construction of gel surface to 80% and you have to put nails soaking with pure acetone at warm temperature or in Steam Off.

 

How to encapsulate pigments?

It is very important to seal the free edge of the nail with a base, from there you have to grab the 4D encapsulator of the nail. Never seal the powders of the tip and use “Easy Finish No Wipe gel” above the powders, then use 4D gel applying the product on the entire nail, at the edge of the nail, also turn the hand, seal and dry meticulously. DO NOT APPLY POWDERS TO NATURAL NAILS ONLY IF THEY ARE THICK, OTHERWISE IS NECESSARY TO MAKE A THIN LAYER OF WONDER OR ARQUITEK TO GIVE STRENGH TO THE NAIL.

 

Process to apply powder pigments:

It is ideal to apply powder in thick or reinforced nails with Arquitek or Wonder.

1. Apply a layer of “Super PH” or “Super Aid” and then “Rubber base”. Seal the edges.

2. Apply 2 thin layer of base tone.

3. Apply “Top No Wipe”.

4. Rub the powder in little amount.

5. Apply “Top No Wipe”.

6. Rub the powder in little amount.

7. Apply “Top No Wipe”.

8. Above the “Top No Wipe”, seal with 4D encapsulator, edge of the nail, the plate of the nail, seal edges and dry.

9. Apply “Top No Wipe”, dry it for 60 sec and seal it well because many layers were applied.

 

How to apply “Matte”?

It is a gel which has to be shaken before applying. You have to apply it in enough quantity and with the “flotada” brush. Transform the “gel color” into velvety texture. You have to dry it for enough time or with a powerful lamp. In led/uv lamps of 36 watts is necessary to dry for 1 min, in led lamps the drying time is for a minute and a half. After drying clean the nail and enjoy the effect.